The Install of the Rhino Rack Roof Rack with Crossbars, part # RSPT08 on your 2010 Range Rover Sport is pretty straightforward.
The plastic molding that runs down the tracks on either side of the roof is removed, and then trimmed. The roof rack tracks are installed into existing hardware, and the plastic roof molding will install around the tracks once it is trimmed. Purchase of the rack does indeed include installation instructions. view full answer...
I wish that would work but Powered Modules like the Tekonsha ZCI Circuit Protected Vehicle Wiring Harness # 119250KIT you are installing need to get power directly from the battery using the included fuse to protect the circuit.
Adding this connector onto an existing circuit could cause it to not receiver adequate power which can cause the connector to stop working, or damage to the module which would now not be covered under warranty due to improper install.
Since going underneath the... view full answer...
Installation of the Stealth Hitches Hidden Rack Receiver # SH49GR does not require any cutting or trimming on your 2022 Land Rover Range Rover. This hitch uses a bolt-on installation so no drilling or welding is required either. It comes with a 2" receiver rated for accessories up to 600 lbs.
If you plan on towing you need the # SH46GR instead which comes with the towing kit. You can also add the towing kit separately with the # SH29GR if you decide you want to tow at a later time. view full answer...
It's generally recommended that you remove any aftermarket roof rack like the # RRRVP05 when taking it through an automatic car wash, but it's not the soap or chemicals that you're worried about causing damage. Removing the rack is done to prevent any of the car wash brushes from snagging on the rack and damaging the roof rack or the vehicle's roof itself. view full answer...
Since this Tekonsha Prodigy RF Brake Controller # TK94FR will actually mount to your trailer you will not need to wire power wire and brake switch wires from your 2006 Range Rover. It will get the signal from the 7-way that is on your vehicle.
Since the blinkers and brake lights are already functional on your vehicle wiring harness the only thing else that you will need to be functional would be the 12 volt power source. What was meant by functional 12-volt power source is basically that... view full answer...
Yes, the Gustafson RV LED Vanity Light # 277-000446 does run off 12 volt power.
If you go to about the 1:25 mark of the linked video review you can see this fixture being hooked into 12 volt power and turned on.
This fixture has an alluring Satin Nickel finish and uses LEDs to ensure a long-lasting, bright light. view full answer...
I totally understand your concern but the Tow Ready Interchangeable Hitch Ball Set # 63803 is totally safe to use and would not come disconnected when either towing or not towing.
I attached a review video for this for more info as well. view full answer...
For your 2012 Land Rover the correct harness to install the Prodigy P3 part # 90195 is the part # 3035-P that you referenced.
From 2000 to 2008 Land Rover was actually owned by Ford so it's not a huge surprise the vehicle is using an older Ford style connector for the brake controller. view full answer...
It sounds like you are hardwiring your Prodigy P2 # 90885 trailer brake controller. If the controller is not powering up the issue would be on the black wire that delivers 12V operating power to the controller via a circuit breaker like # PK54230. The white ground wire also of course must be connected to the battery negative terminal.
You can refer to the linked article on brake controller installation to see the complete wiring scheme. The red wire connects to the cold side of the brake... view full answer...
Go To Results